Bottle opener dimensions?

Signed-In Members Don't See This Ad
thewishman

thewishman

Member
Joined
Mar 9, 2006
Messages
8,210
Location
Reynoldsburg, Ohio, USA.
Looking at adding bottle openers to my offerings. Can anyone tell me what the diameter of the base is? Not the hole that needs to be drilled, the part that caps the hole.

Thanks in advance for the info!:smile:

Berea?

PSI?
 
Signed-In Members Don't See This Ad
I have one out in my shop - I'll measure it later this afternoon when I get a chance to go out there if you don't get an answer before then. I believe it's a PSI kit - I got it from Woodturningz.
 
Apparently it is a nominal 3/4"'dia. I only have one on hand right now, but I measured it to be 0.77" on the inch scale & 19.55 on the mm scale. This is the PSI PKBOTTCH kit.
 
Last edited:
I buy my openers from Rockler. A little more expensive than some of the others but I like the look and feel of them. They are 1" in diameter at the opener end...

attachment.php

http://www.penturners.org/forum/attachment.php?attachmentid=147536&stc=1&d=1460815883
 

Attachments

  • OPen Dec 14.jpg
    OPen Dec 14.jpg
    103.7 KB · Views: 3,068
You must log in or register to reply here.
Back
Top Bottom