Long Shot Question

Signed-In Members Don't See This Ad
KenB259

KenB259

Member
Joined
Dec 24, 2017
Messages
4,551
Location
Michigan
Does anyone recognize this screw and where it may have fell off a Laguna 12/16 lathe? I heard it hit the floor while I was using the lathe. I don't see anywhere where it might go. Lathe runs fine with no issues.
 

Attachments

  • IMG_6656.jpeg
    IMG_6656.jpeg
    629.1 KB · Views: 18
I looked over my 1216 - The only screw I found that looks like that is on the little tool rack that is mounted on the front of the lathe, on the right side. There are actually 2 screws holding that little rack in place.
 
KMCloonan said:
I looked over my 1216 - The only screw I found that looks like that is on the little tool rack that is mounted on the front of the lathe, on the right side. There are actually 2 screws holding that little rack in place.
Click to expand...
Are you talking about the little tool rack that's mounted on the tailstock?
 
You must log in or register to reply here.
Back
Top Bottom