RosezPenZ
Member
A question to those that use Gorilla Glue. How do you keep the glue expansion from pushing the tubes out? Should I be cutting the blanks longer? Rubber bands, tape, clamp?
Help please.
Help please.
A question to those that use Gorilla Glue. How do you keep the glue expansion from pushing the tubes out? Should I be cutting the blanks longer? Rubber bands, tape, clamp?
Cutting the blanks longer would be a waste. When I tried the GG, I used a clamp just long enough for it to start to set. However, I gave up on this. The only reason I used GG was to not "eat" the paint on the inside of blanks. I figured out that if I give the paint enough time to try, CA doesn't cause me any issue and so the GG wasn't worth the hassle.
A question to those that use Gorilla Glue. How do you keep the glue expansion from pushing the tubes out? Should I be cutting the blanks longer? Rubber bands, tape, clamp?
Help please.
Masking tape, but Gorila Glue is a PITA, and messy, I went back to Epoxy, also there has been some of discussion about GG expanding after a time and causing cracking, I have never had it happen, but some have.
A question to those that use Gorilla Glue. How do you keep the glue expansion from pushing the tubes out? Should I be cutting the blanks longer? Rubber bands, tape, clamp?
Help please.
Don't use Gorilla Glue...
Epoxy is far and above the best method. IMHO