Todays work

Signed-In Members Don't See This Ad
See more from Ligget

Status
Not open for further replies.

Ligget

Member
Joined
Jan 13, 2005
Messages
13,477
Location
Bonnybridge, Scotland.
Here are a couple I made today.
First is a Afzelia Burl one-piece pencil made from a rhodium Comfort kit, CA finish.


200773201742_pencil.jpg



Next is a "dyed myself" Curly Maple Comfort pen in rhodium plating, again a CA finish. Bad photo sorry.


200773201813_comfort.jpg



Thanks for looking, comments welcomed!:)
Cheers
Mark
 
Signed-In Members Don't See This Ad

rhahnfl

Member
Joined
Jan 27, 2007
Messages
1,211
Location
Fleming Island, Florida, USA.
What kind of stroke do you have to have on your drill press to make one like that? That is something different and nice too. I'm impressed!! Always something new and creative on this site.
 

Ligget

Member
Joined
Jan 13, 2005
Messages
13,477
Location
Bonnybridge, Scotland.
Chris - I drill these on my lathe with a long drill bit.
John - the Comfort click pencil is OK but I am only going to use them in my workshop, the lines at the top of the pencil are burned on with wire.

Thanks to all for the positive feedback, helps me move forward.[:D]
 
Status
Not open for further replies.
Top Bottom