sschering
Member
Any tips for turning Red Palm before I start?
I drilled and glued up the blanks yesterday with epoxy. They have had all night to set.
I know after I trim to length I need to soak the ends with thin CA and go slow with a sharp skew.
Any other tips like run down to woodcraft and get a carbide tool? hehe
I was thinking I may take the corners off on the band saw to reduce the chance of a catch early on.
Thanks!
I drilled and glued up the blanks yesterday with epoxy. They have had all night to set.
I know after I trim to length I need to soak the ends with thin CA and go slow with a sharp skew.
Any other tips like run down to woodcraft and get a carbide tool? hehe
I was thinking I may take the corners off on the band saw to reduce the chance of a catch early on.
Thanks!
Last edited: