Toni
Member
I have been busy with making zen blanks. A little insight on my blanks if you have never tried one.
www.claypenblanks.com
Polymerclay is very easy to finish. My blanks
are made to fit the tube so all that is required is. Once you receive the blank. Place it on the lathe with bushings. Apply CA. Sand the CA with sandpaper. If you sand through the CA apply more. Never sand my blanks or you will sand off the design. Then apply Polish and you are done.
Now you are going to take sandpaper lay it on a flat surface and rotate the ends round and round till flush with the tubes.
Also, Do not use stickfast
Tips: You need to wax your bushings .... or the ca will stick to the bushings as well as the tube and it might chip.
www.claypenblanks.com
Polymerclay is very easy to finish. My blanks
are made to fit the tube so all that is required is. Once you receive the blank. Place it on the lathe with bushings. Apply CA. Sand the CA with sandpaper. If you sand through the CA apply more. Never sand my blanks or you will sand off the design. Then apply Polish and you are done.
Now you are going to take sandpaper lay it on a flat surface and rotate the ends round and round till flush with the tubes.
Also, Do not use stickfast
Tips: You need to wax your bushings .... or the ca will stick to the bushings as well as the tube and it might chip.