mikemac
Member
Hey there...
I've recently purchased a bunch of bottle stoppers and a mandrel from WoodnWhimisies, but I'm have a problem drilling the hole and tapping it. I can't seem to get the tap size down, so I can thread it onto the mandrel. Its either TOO tight, and impossible to get off after I've turned it, or too LOOSE, and strips once I start turning.
Could someone perhaps more familiar with tap&dies provide me with the correct tap and drill size, please?
Thanks in advance;
Mike
I've recently purchased a bunch of bottle stoppers and a mandrel from WoodnWhimisies, but I'm have a problem drilling the hole and tapping it. I can't seem to get the tap size down, so I can thread it onto the mandrel. Its either TOO tight, and impossible to get off after I've turned it, or too LOOSE, and strips once I start turning.
Could someone perhaps more familiar with tap&dies provide me with the correct tap and drill size, please?
Thanks in advance;
Mike