Woodchipper
Member
I have an Accord Twist pen kit. For some unknown reason, the tube and finished blank are too short! The kit and tube are no longer available that I could find. Here are the tube spec's= diameter 0.368, length 3.50. Checking the supplier list, I find a lot of tubes, 0.368 but the longest is for the wrench kit at 2.50. I could cut, 3-5/8, and drill a blank, 3/8 bit, but was wondering if I could cut and stack two tubes in the blank. I have a stash of extra tubes JIC. My gun club has an arrow trimmer that would be precise and give a smooth finish.
I can't figure out how a blank and tube could be trimmed to 3-1/6 instead of 3.50! Wrong tube in the kit?
Your advice, experience, expertise is most welcome as always.
I can't figure out how a blank and tube could be trimmed to 3-1/6 instead of 3.50! Wrong tube in the kit?
Your advice, experience, expertise is most welcome as always.