Woodchipper
Member
I goofed big time. I was assembling a Woodcraft cartridge pen, P/N 151303. Following the instructions (77C73) for the click pen, I inserted the small tube "F" into the Clip Retainer as instructed. Anyway, it went in crooked, bent and now I have a good supply of spare parts. I was in WC this week and asked if they had any odds and ends. No, had to buy a new kit. This is the part that requires that 9/16" be exposed. I'm betting that someone here has dealt with this in the past. BTW, I checked with some of the extra tubes on the rack at WC but the diameters were either too big or too small.
Any suggestions, replacement material, etc. is most welcome.
Any suggestions, replacement material, etc. is most welcome.