Daniel
Member
For all of you scroll saw workers.
I have a huge project I am working on. I have used my saw quite a bit but have always gotten by on the $4.00 4 packs of blades from the hardware store.
I have been looking on line for blades in bulk and have mainly found Olson or Flying Dutchman blades
I am looking for recommendations in both brand and supplier of blades.
I will be cutting tons of cedar both 3/4 and 7/4
I will most likely do most of the 7/4 on my band saw but there will be small finish cuts I have to do on the scroll saw.
The project is in the round so both sides of the cut need to be clean.
So far I am looking at No. 5 Reverse tooth for the 3/4 material
No.9 Reverse tooth for the 7/4 material.
One extra question is what is the smallest diameter I can expect to cut with the No. 9 blade?
With the few blades I did have I figure I will need about half a gross of them. so if I have to buy that many I would like them to be as quality as I can get with some quick research.
Thanks ahead of time.
I have a huge project I am working on. I have used my saw quite a bit but have always gotten by on the $4.00 4 packs of blades from the hardware store.
I have been looking on line for blades in bulk and have mainly found Olson or Flying Dutchman blades
I am looking for recommendations in both brand and supplier of blades.
I will be cutting tons of cedar both 3/4 and 7/4
I will most likely do most of the 7/4 on my band saw but there will be small finish cuts I have to do on the scroll saw.
The project is in the round so both sides of the cut need to be clean.
So far I am looking at No. 5 Reverse tooth for the 3/4 material
No.9 Reverse tooth for the 7/4 material.
One extra question is what is the smallest diameter I can expect to cut with the No. 9 blade?
With the few blades I did have I figure I will need about half a gross of them. so if I have to buy that many I would like them to be as quality as I can get with some quick research.
Thanks ahead of time.