Daddy1
Member
I just started casting. I was going along fine. I did some clear cast which hardened great and quick. I did some with powder dyes and the same result except the last one came out rubbery. I then tried with acrylic paint and has been 24 hours and it is sticky and rubbery.
Could it be the temp? I do it in the basement and it is about 65 degrees. Could it be the paint? I used 7 drops/oz of hardener as my instructions stated.
Any suggestions?
Could it be the temp? I do it in the basement and it is about 65 degrees. Could it be the paint? I used 7 drops/oz of hardener as my instructions stated.
Any suggestions?