Penultimate
Member
Greetings
I purchased this piston fill assembly from Richard Greenwald and need some advice on how to make a pen. Do you have any ideas how to use the ink window tube as is? I was thinking about turning a body to fit over it with a set of ports that would go thru the body to the clear window. Or, I could turn down the 0.05" wall thickness a little and slip a body over that.
Also, the web site says that the threaded portion is for a JOWO 6.4x.6 nib. Does anyone know where to get one? Most of the sites I visit don't list that thread size.
I appreciate any comments, you guys are a very talented group.
Thanks in advance
Mike
Sent from my iPad using Penturners.org mobile app
I purchased this piston fill assembly from Richard Greenwald and need some advice on how to make a pen. Do you have any ideas how to use the ink window tube as is? I was thinking about turning a body to fit over it with a set of ports that would go thru the body to the clear window. Or, I could turn down the 0.05" wall thickness a little and slip a body over that.
Also, the web site says that the threaded portion is for a JOWO 6.4x.6 nib. Does anyone know where to get one? Most of the sites I visit don't list that thread size.
I appreciate any comments, you guys are a very talented group.
Thanks in advance
Mike
Sent from my iPad using Penturners.org mobile app