jskeen
Member
I ran across this set of apparently brand new bushings while organizing the rest of them and have no idea what they go to. I tried looking at Joe's bushing database program with no luck, and tried them against all the kits and bushings that I have, and came up blank. They are for a pen that uses the 10mm cigar size tubes, but are way smaller than cigar bushings, and they DO NOT fit the screw cap euro or FTA tubes (too large) (even though they are listed as using a 10mm drill bit)
Measurements are top 0.490, large center 0.494 small center 0.442 and small end 0.442 and the tube section is 0.357.
Any help Id'ing these things would be most appreciated.
Measurements are top 0.490, large center 0.494 small center 0.442 and small end 0.442 and the tube section is 0.357.
Any help Id'ing these things would be most appreciated.