Chrome
Member
Hi All,
Keen on casting my own unique pen blanks... I did a lot of casting as a youth, but almost 30-years later, I'm going through a learning curve once again...
My first attempt resulted in an extremely hot heaving spitting, steaming mess crackling and cracking with noxious fumes pumping out into the air. However I've prepared well and already have breathing kit (Trend Airshield Pro), so was ok. I know I added far too much hardener...
The next day I broke it up into chunks, dropped it into a mold and re-cast it with a flesh colored mix binding it. This is the result, and I'm pleased to say it's my first successful batch of pen blanks... here's one blank from the five I produced. I think it will make very unique pens.
What do you think?
I can't wait to get some more on the go...
Cheers, Chrome
Keen on casting my own unique pen blanks... I did a lot of casting as a youth, but almost 30-years later, I'm going through a learning curve once again...
My first attempt resulted in an extremely hot heaving spitting, steaming mess crackling and cracking with noxious fumes pumping out into the air. However I've prepared well and already have breathing kit (Trend Airshield Pro), so was ok. I know I added far too much hardener...
The next day I broke it up into chunks, dropped it into a mold and re-cast it with a flesh colored mix binding it. This is the result, and I'm pleased to say it's my first successful batch of pen blanks... here's one blank from the five I produced. I think it will make very unique pens.


I can't wait to get some more on the go...
Cheers, Chrome
