mick
Member
To any of our electrican members, My Jet 1014 vs that I used as a dedicated buffing station kicked the bucket. Control panel tried to burn itself up. I've had this lathe 15 or so years and the control panel is around $300.... and is out of stock everywhere I've looked. I can't see spending that kind of money on it anyway.
My wheels got to spinning and wondering if I could the motor be hooked up to run single speed, which is all I'd need to use as a buffer.
I'll appreciate any and all advice... I'm not proud.
My wheels got to spinning and wondering if I could the motor be hooked up to run single speed, which is all I'd need to use as a buffer.
I'll appreciate any and all advice... I'm not proud.