lorbay
Member
This is a small Eucalyptus dish with a Milliput epoxy inlay.
Lin
Lin
Milliput
- Thread starter lorbay
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Lucky2
Member
I like the bowl, but personally, I think you have the wrong base for this bowl. It's to narrow and square, if you expect to use the bowl any amount. It's fine if you don't intend to use the bowl any, but it still doesn't do a thing for the bowl. The bowl is fine without a base, it doesn't need to be embellished upon.
Len
Len
lorbay
Member
Lucky2
Member
Ha. Ha. Too funny. It's just a stand while the WOP dries.
Well that's better, cause it sure doesn't look like a nice base. Knowing that it's only a temporary base, makes me like the bowl even more.
Len
lorbay
Member
Thanks Mal and Len.
Mal yes this could be done an a pen. In this case it's just over 3/32nds . If I were to do it any shallower I would put a little regular epoxy in the grove first.
Lin
Lucky2
Member
Lin, I hope that you don't mind me asking, but I was wondering. Where did you purchase the Milliput, and was it expensive?? Are those the only two colors you got, or did you get all four of them? It's something that I would like to try out, but I thought that it was only available in Britain. But I see that you're from Canada (as am I), so it must be available on this side of the Atlantic.
Len
Len
wouldentu2?
Member
Milliput is available at Hobby Lobby and on Amazon.
