jkoehler
Member
I know most everyone uses micro-mesh for finishing.
Has anyone tried the micro abrasives from Lee-Valley?
I see they have 5 micron which equals 1800 MM or 600 sandpaper.
They also have .5 micron which isn't even on the chart.
Has anyone tried it and is this product any good for finishing?
Has anyone tried the micro abrasives from Lee-Valley?
I see they have 5 micron which equals 1800 MM or 600 sandpaper.
They also have .5 micron which isn't even on the chart.
Has anyone tried it and is this product any good for finishing?