Dale Allen
Member
This raised panel effect is done with the TS at a 12 degree tilt against the fence. A 1/16" step is 3/4" from the edge.
I like the effect and would like to duplicate it on a future project.
However, I don't like the amount of sanding needed to get rid of the saw marks.
I've been looking for a router bit to do the same thing. Most don't give all of the dimensions and the only thing I found was a raised panel bit at 15 degrees.
Any ideas?
I like the effect and would like to duplicate it on a future project.
However, I don't like the amount of sanding needed to get rid of the saw marks.
I've been looking for a router bit to do the same thing. Most don't give all of the dimensions and the only thing I found was a raised panel bit at 15 degrees.
Any ideas?