Woodchipper
Member
I'm taking a break for two reasons- to let the knees quit screaming and to ask a question.
I'm applying Tite Bond Thin CA to a cherry blank. I'm using a paper towel to apply the CA then give it a quick shot of accelerator. I'm noticing that the CA has lines in it like sanding marks. I checked after sanding under a bright light and a magnifying glass to check for sanding marks before applying CA. None there. Before I did something I would regret, I thought I would put the question to the forum. I have MM and Hut Ultra Gloss. What is recommended? Your help is most appreciated.
Using a high RPM but noticed that another thread had one person going down to 500 RPM.
I'm applying Tite Bond Thin CA to a cherry blank. I'm using a paper towel to apply the CA then give it a quick shot of accelerator. I'm noticing that the CA has lines in it like sanding marks. I checked after sanding under a bright light and a magnifying glass to check for sanding marks before applying CA. None there. Before I did something I would regret, I thought I would put the question to the forum. I have MM and Hut Ultra Gloss. What is recommended? Your help is most appreciated.
Using a high RPM but noticed that another thread had one person going down to 500 RPM.