Madman1978
Member
Now that I have the lathe here and on its little table, I am thinking of what I need now. I did buy the Wen Chuck with the lathe. For turning tools I have the tools I use for pens and such. One set I looked at had these in the set, 1/2" round nose, 1" square nose, 1/4" and 1/2" spindle gouge, 3/16" diamond parting tool, 3/8" bowl gouge, 3/4" roughing gouge, and 3/4" skew. I am quite lost here on all of this. lol
So I am asking for some input here.
-What Chisels will I need.
-What other tools will I need?
-What sharpening system to use
Actually, any suggestions would be helpful
Thank you in advance.
So I am asking for some input here.
-What Chisels will I need.
-What other tools will I need?
-What sharpening system to use
Actually, any suggestions would be helpful
Thank you in advance.