Jet VS lathe

Signed-In Members Don't See This Ad
0

08K.80

Member
Joined
Dec 31, 2012
Messages
390
I found this on Craigslist and it comes with the stand and four chisels for $200.00. Do you think this is a good deal?
It states that it has been used for making pens only.
What should be looked at for potential problems?

Thanks!







00303_dxtpM4lP01W_600x450.jpg
 
Signed-In Members Don't See This Ad
If everything checks out - especially the alignment - that is a screaming good deal in my opinion.
 
It's four years old, and it comes with a live center, three inch faceplate, the stand, and a beginner set of chisels.
It's the 1014vs model and is non-indexed. He said he would take $175.00 for it.
 
08K.80 said:
It's four years old, and it comes with a live center, three inch faceplate, the stand, and a beginner set of chisels. It's the 1014vs model and is non-indexed. He said he would take $175.00 for it.
Click to expand...
I'm not even looking for one and I'd buy it

If you want it, don't hesitate

It will be gone

You will love having variable speed if you don't now!
 
If the motor runs and there aren't any cracks in the cast iron, buy it. You could probably make 50% by reselling it in the right place if you didn't want it.
 
Dan Masshardt said:
08K.80 said:
It's four years old, and it comes with a live center, three inch faceplate, the stand, and a beginner set of chisels. It's the 1014vs model and is non-indexed. He said he would take $175.00 for it.
Click to expand...
I'm not even looking for one and I'd buy it

If you want it, don't hesitate

It will be gone

You will love having variable speed if you don't now!
Click to expand...
ditto.

for that price, I would buy it and re-sell my non-VS 1014

:biggrin:
 
You must log in or register to reply here.
Back
Top Bottom