Quality Pen
Member
Finally starting to wrap my head around collets, chucks, tapers, etc etc...
So, I wanted to know if this is what I need to fit an MT1 lathe (shop fox w1704):
#1 Pin Jaws
http://www.pennstateind.com/store/CJAWPC.html?prodpage=1CJ
+
Utility Grip 4 Jaw Chrome Lathe Chuck System
http://www.pennstateind.com/store/CUG3418CCX.html?prodpage=1CU
and then a
1/2 in. Drill Chuck #1MT
http://www.pennstateind.com/store/TM31.html?prodpage=1TM
+ drill bit.
Am I missing something? Will this do the job?
Thanks so much.
Part of what I don't understand is that the chucks in PSI magazine say the pin jaws internal grip is 1" to 2 1/8" but my pen blanks are like a half inch. So I'm thinking I dont really know what that means lol.
So, I wanted to know if this is what I need to fit an MT1 lathe (shop fox w1704):
#1 Pin Jaws
http://www.pennstateind.com/store/CJAWPC.html?prodpage=1CJ
+
Utility Grip 4 Jaw Chrome Lathe Chuck System
http://www.pennstateind.com/store/CUG3418CCX.html?prodpage=1CU
and then a
1/2 in. Drill Chuck #1MT
http://www.pennstateind.com/store/TM31.html?prodpage=1TM
+ drill bit.
Am I missing something? Will this do the job?
Thanks so much.
Part of what I don't understand is that the chucks in PSI magazine say the pin jaws internal grip is 1" to 2 1/8" but my pen blanks are like a half inch. So I'm thinking I dont really know what that means lol.