Herb G
Member
For finishing, then you need this stuff to prevent sticking.
Tri-Flow has Teflon in it. Make sure to spray the bushings before you use them. A couple of light coats are better than one thick one.
Allow the bushings to dry well between spraying them with the Tri-Flow.
Try not to use accelerator on them as it degrades the Teflon coating.
Re-spray the bushings before & after every use, and the CA glue will not stick to them.
I hope this tip helps someone out there.
Tri-Flow has Teflon in it. Make sure to spray the bushings before you use them. A couple of light coats are better than one thick one.
Allow the bushings to dry well between spraying them with the Tri-Flow.
Try not to use accelerator on them as it degrades the Teflon coating.
Re-spray the bushings before & after every use, and the CA glue will not stick to them.
I hope this tip helps someone out there.