kirkfranks
Member
Ok so I am thinking about making the switch to Turning Between Centers.
I will need a dead center but would rather have one with a straight back end to use in the Beall Chuck instead of a morse taper. On my lathe I notice much better "trueness" using the chuck vs. the taper.
So does anyone make such a dead center?
I would also like a small steb center with the same arrangement if possible.
So send me your suggestions and links.
I will need a dead center but would rather have one with a straight back end to use in the Beall Chuck instead of a morse taper. On my lathe I notice much better "trueness" using the chuck vs. the taper.
So does anyone make such a dead center?
I would also like a small steb center with the same arrangement if possible.
So send me your suggestions and links.