ed4copies
Local Chapter Manager
Please move entries directly to Johnathan's thread- I would delete this one, if I knew HOW. Per Randy's LOGICAL request.
Since Johnathan said I should help any way I could, I printed CSUSA's instructions on the crush grinder.
The printed dimensions seem to be impossible. But, then, I have never seen the mechanism.
The "Through hole" is listed at 11/16"-this seems too small
The hole in the top is listed at 15/16", but is shown SMALLER than the above through hole. I believe it SHOULD be smaller, but 15/16 is GREATER than 11/16 (yes, I was a math major, since you asked!!)
The bottom recesses are shown as 1 3/4 at the bottom and 1 9/16 for the mechanism-both of which seem feasible.
Although, I would leave 1/2 - 3/4 inch of depth at the bottom, not the 1" shown, but again, I have NEVER SEEN this mechanism.
Has anyone made one, if so, what is WRONG with this picture!!!???
Since Johnathan said I should help any way I could, I printed CSUSA's instructions on the crush grinder.
The printed dimensions seem to be impossible. But, then, I have never seen the mechanism.
The "Through hole" is listed at 11/16"-this seems too small
The hole in the top is listed at 15/16", but is shown SMALLER than the above through hole. I believe it SHOULD be smaller, but 15/16 is GREATER than 11/16 (yes, I was a math major, since you asked!!)
The bottom recesses are shown as 1 3/4 at the bottom and 1 9/16 for the mechanism-both of which seem feasible.
Although, I would leave 1/2 - 3/4 inch of depth at the bottom, not the 1" shown, but again, I have NEVER SEEN this mechanism.
Has anyone made one, if so, what is WRONG with this picture!!!???