davinci27
Member
So I still don't have a new hand wheel for my tailstock, so there's no precision drilling which means no pen making. In the mean time, here's a little box I made out of a scrap of burl. Mark St. Leger did a demo at my turning club. he made a small box out of a burl scrap. Here's the handout: http://www.markstleger.com/Rectangular Box with a Burl Edge Handout.doc.
I decided to give it a try and here's what I ended up with. This scrap is about 1.5" wide X 1.5" tall X 5.5" long. The opening is around 0.75" in diameter. The finish is wipe on poly. It was a fun little box and I can't wait to do a few more.
This scrap had been laying on my floor for over 2 years.
I decided to give it a try and here's what I ended up with. This scrap is about 1.5" wide X 1.5" tall X 5.5" long. The opening is around 0.75" in diameter. The finish is wipe on poly. It was a fun little box and I can't wait to do a few more.
This scrap had been laying on my floor for over 2 years.
Attachments
Last edited: