gimpy
Member
Hi Folks,
I just recently purchased two boxes of Elk antler's.
The thread stated that the person was cleaning out his shop and had 2 boxes of elk antlers.
And that is just what they were, pieces of antlers cut no more than 1/2" thick, and the full thicker pieces were appr. 3/4" dia, the problem being, they where less than 2" long...........
So, beware of what you are purchasing.....ask questions......
The individual stated that he had a tape measure showing how long the pieces were, but he failed to tell you how thick they were.......
This is the 2nd time I cot bunt on this site, there will not be a third......
I did have contact via phone, and he stated that the pieces are basically used for casting......Do you think that should have been stated in the thread
If I see a post on a "pen forum" for a piece of product, wouldn't you think that it would be a usable piece to at least make a pen,
The moral of the story is make sure you know what you are buying, before you buy it.....
Thanks for the ear....needed to vent
I just recently purchased two boxes of Elk antler's.
The thread stated that the person was cleaning out his shop and had 2 boxes of elk antlers.
And that is just what they were, pieces of antlers cut no more than 1/2" thick, and the full thicker pieces were appr. 3/4" dia, the problem being, they where less than 2" long...........
So, beware of what you are purchasing.....ask questions......
The individual stated that he had a tape measure showing how long the pieces were, but he failed to tell you how thick they were.......
This is the 2nd time I cot bunt on this site, there will not be a third......
I did have contact via phone, and he stated that the pieces are basically used for casting......Do you think that should have been stated in the thread
If I see a post on a "pen forum" for a piece of product, wouldn't you think that it would be a usable piece to at least make a pen,
The moral of the story is make sure you know what you are buying, before you buy it.....
Thanks for the ear....needed to vent