Best Way to finish stabilized flame box elder

Signed-In Members Don't See This Ad

DorenaGay

Member
Joined
Sep 8, 2018
Messages
6
Location
Richmond, TX
This is my first time working with any stabilized wood. So far I am loving the stabilized flame box elder! I am about to finish turning my pen and am trying to decide the best way to finish it. Will CA work? Any other suggestions are appreciated! BTW - I am new to this site and am very excited to be a part of this group!!!
 
Signed-In Members Don't See This Ad

leehljp

Member Liaison
Joined
Feb 6, 2005
Messages
6,795
Location
Tunica, MS,
Welcome Dorena. If you have experience with CA, it is a great finish, tough and quick. However it can have a learning curve to it for some. Lacquer and some urethanes are also good but they are not nearly as quick in curing.
 

DorenaGay

Member
Joined
Sep 8, 2018
Messages
6
Location
Richmond, TX
Thanks, Hank! Yes - I have experience with CA. It did take me some time to figure it out, but I finally have! I just wanted to make sure it would be OK to do a CA finish on the stabilized wood! I will try to remember to post a picture when I finish - assuming it turns out good! Yes - that was a pun!
 
Top Bottom