Scott
Member
We are holding a little contest later this summer in conjunction with Woodturning Design Magazine. We have come up with four categories, which are: Casting, Segmenting, Kitless and Open class. I have the rules written for this contest, but I have a couple of questions on some of the categories.
In the "Casting" category, should the casting be done by the individual submitting the pen, or should they be allowed to purchase the cast blanks?
Same for the Segmenting category, should the penmaker produce the segmented blank or can they be allowed to purchase all or part of the blank?
In the kitless category, should we allow as many kit parts as they want as long as they aren't visible, or should we limit the kit parts to only a few certain parts? If so, which parts should we limit it to? My idea is to allow any kit parts as long as none are visible when the pen is closed, with the exception of a clip.
Other comments on this contest are gladly accepted, although I have a relatively short time to get this done. Thanks!
Scott.
In the "Casting" category, should the casting be done by the individual submitting the pen, or should they be allowed to purchase the cast blanks?
Same for the Segmenting category, should the penmaker produce the segmented blank or can they be allowed to purchase all or part of the blank?
In the kitless category, should we allow as many kit parts as they want as long as they aren't visible, or should we limit the kit parts to only a few certain parts? If so, which parts should we limit it to? My idea is to allow any kit parts as long as none are visible when the pen is closed, with the exception of a clip.
Other comments on this contest are gladly accepted, although I have a relatively short time to get this done. Thanks!
Scott.