advice

I finally took the plunge into GluBoost, as my Pens Plus bottle (at over half full, as it seems) has gone bad. Given the amount of waste I've had with Pens Plus, despite the fact that I like it as a finish, and love that there are zero health implications with it, I'm giving GluBoost a try. So...

Fairly new to pen turning, although woodworking is almost second nature.. I am hoping to use pen turning as a means of subsidizing my youth pastor income, any recommendations on how/where to sell? My wife and I opened an Etsy shop, but that market seems to be flooded with people selling pens for...

In this thread, Deceit, Dave Bledsoe posted this: I didn't want to hijack George's thread, but the sentence above caused me to react with: (a) that's just too much spam which suggests the email service provider being used stinks at their job. So much of the regularly targeted spam is easy to...

I am starting on my first ever real work shop. I have been offered room in the basement. an area that is 10'X11' with 7' ceilings, it is almost a square area. The floor is of course concrete and the ceiling is open rafters. My only limitation is that I have to build 2 walls and frame out for a...

I'm about to start my first Majestic from PSI using an Ancient Mars blank I bought from Exotic. I haven't touched anything. Before I start, is there anything I should know about the Majestic that isn't included in the directions? Thank you for your help. Regards, t.

Hey folks, I need some advice… I am looking to upgrade to a bigger lathe and was wondering what you might know about the Jest 1442EV or the Jet 1642EV… Have you use either? I know the specifications on each but if you have one or the other what do you consider some of it’s strengths or...