Trouble drilling on the lathe

Signed-In Members Don't See This Ad

johngmccune

Member
Joined
Mar 29, 2018
Messages
22
Location
Spring, Texas, USA
I'm having trouble drilling on the lathe because some blanks require the jaws to be at their extreme widest (and a few are simply too large) and for others -- like the rounded ones from Hobble Creek -- sometimes can't be held tightly even with the jaws at their smallest. Any comments or suggestions?
 
Signed-In Members Don't See This Ad
What I would do is first true the entire blank between centers. Get it as consistent as possible in size. 18, 19, 20 mm for the whole blank, then put it in a collet chuck, using an appropriately sized collet. Then, face off the exposed end to perfectly flat and drill your tube size. Your hole should be fefectly centered and ready for gluing in your tube.

Yes, it takes more time, but it increases your skill set. Try truing the blank with a skew to a perfect cylinder between centers. Your drilling will become much more consistent with a trued blank.
 
Back
Top Bottom