Kalidascope wands

[RDH79]

I have been making the wand kalidascopes from PSI. They only have 3 different colors. I have been asked for extra wands in different colors and can not find the right size. The length is right 6" but the PSI wands are 1/2" The ones I have found are 3/8" Does anyone know of where to get this size. I sent some emails to a few places with no luck. Thanks

Rich H

 

[LEAP]

http://polymerclayprojects.com/Wands.htm

Take a look at these. The company has a lot of Kscope parts.

 

[ed4copies]

WARNING!!

I bought some at a gift show, thinking I would resell them. They have VERY LITTLE in them--the colored pieces are sparse. I would not sell them, they are junk.

I say this, only because the pieces at the gift show were MUCH nicer. So, IF you buy from someone (ABSOLUTLELY NO REFLECTION ON THE ABOVE company, I do NOT know them, at all!!!), check out the quality before buying a bunch.

I AM still looking for good ones.

 

[RAdams]

I dont know about Kscope wands, but the link up there has some pretty interesting stuff. They have a slimline kit that threads together. It says its not for lathe turning, but i bet it could be modded for some use or the other...

I just might have ot order a couple of those and check em out.

 

[Toni]

Ed you are right about the wands...

 

[ed4copies]

Ed you are right about the wands...

Thanks Toni! Do you have any experience with "Boston craft" shown above?? Or have you found a GOOD source?

Dawn and I used to go to major gift shows, but have not done so in a couple years. I would love to offer K-scope supplies on exotics, but have not been able to find quality that I find acceptable. Any leads are appreciated!!

(BTW, for everyone who has never tried this, the gift show people usually have a 500 unit minimum)