Latest activity

Yes, I used our laser.

I don't use it for filling voids; gluing tubes only. If filing voids, I would opt for 5 minute epoxy.

Hmm, could be. I've always just guesstimated equal parts when I put it on my mixing plate.

30 minutes is kinda long for me when I'm filling voids in a curved surface. Just more time for the epoxy to run. Plus my use is...

I was thinking of trying the 15 minute. The 5 minute seems to cut the, "what else should I cover with this batch" time really short.

I use Two Ton epoxy with a working time of about 30 minutes. Can do four or five pens at one time. Let it set up overnight and then...

I was kidding but thanks for the lesson on rolling pins. The latter should be good for pierogi. Should have some cherry among other...

My latest box to be included in the SWAT collection. Its a threaded box and the wood is Red and Green SpectraPly and the finish is...

I usually don't add splines to these but decided to change it up a bit. I really like the look with the splines. The box is maple and...

I usually don't add splines to these but decided to change it up a bit. I really like the look with the splines. The box is maple and...

Yes, I used our laser.

Sounds to me like your mixing of the JB was a bit off - not enough hardener. I like bsi epoxy, they have 15 and 30 minute open time...

Hi. So if I understand correctly, you would multiply the cost per blank by 5 to arrive at the total cost per pack, then based upon the...

This by far is my most favorite pen to make. Not really hard to make but for some reason every time I see one it takes me back to the...

Thanks for all the kind words. I just heard back after the show with bid results. All of the pens were well received and I was very...