Zirnike
Member
When attempting to remove the kit from the tubes of a completed but messed up pen, remember not to clamp the tube _ON_ the section where the press fit is.
This has been a tip from Zirnike.
(aside, but related: You know you're a penturner when you have a 27/64 drill bit and a 29/64 bit, but not a 7/16 (28/64 for the math impaired...))
This has been a tip from Zirnike.
(aside, but related: You know you're a penturner when you have a 27/64 drill bit and a 29/64 bit, but not a 7/16 (28/64 for the math impaired...))