Ulises Victoria
Member
Hello all.
Great advise I've been getting here. Thank you all, folks.
Someone suggested in another post, that I should try Alumilite to cast plastic blanks instead of PR.
I've been doing some research but I always ask my fellow penturners here.
My first concern about Alumilite is how does it responds to glue?
Since I am thinking about doing some segmenting with it, does it glue well with CA,Gorilla, Epoxy?
I've seen that Aumilite comes as "water clear" or already colored, so this may be good since you save the step of mixing colorants.
Any specific brands somebody can recommend as your favorite?
Any input will be greatly appreciated.
Great advise I've been getting here. Thank you all, folks.
Someone suggested in another post, that I should try Alumilite to cast plastic blanks instead of PR.
I've been doing some research but I always ask my fellow penturners here.
My first concern about Alumilite is how does it responds to glue?
Since I am thinking about doing some segmenting with it, does it glue well with CA,Gorilla, Epoxy?
I've seen that Aumilite comes as "water clear" or already colored, so this may be good since you save the step of mixing colorants.
Any specific brands somebody can recommend as your favorite?
Any input will be greatly appreciated.
