Would this do for Pressure Pot ?

Signed-In Members Don't See This Ad

Celt40

Member
Joined
Nov 26, 2007
Messages
119
Location
Scotland UK
Hi after looking through Ebay for stuff to make pressure pot for casting. I found this iten No 310037519876 Will this work the same as you guys have or is it just a toy. As usual everything that looks go is always States side!!!!!
 
Signed-In Members Don't See This Ad
Thanks Bob & Jim, If i was able to ship from HF what else would i need to create the pressure?????. Would this be ready to connect??? [:I]
If it is a complicated thing to set up after buying the PPot then i fear that the understanding will fly far above the surface of my "Shinny Head", not the best at mechanical understanding. Thanks Guy's so far.
 
Originally posted by Celt40

Thanks Bob & Jim, If i was able to ship from HF what else would i need to create the pressure?????. Would this be ready to connect??? [:I]
If it is a complicated thing to set up after buying the PPot then i fear that the understanding will fly far above the surface of my "Shinny Head", not the best at mechanical understanding. Thanks Guy's so far.

Here's a pictorial assembly guide for my HF pot. Currently, this is a pressure only pot since the vacuum unit is on backorder from HF.

Once I had the fixtures removed and the parts at hand, the assembly took about 15 minutes. The original instructions came from Lee Thomas (Firefyter-EMT).

tn_HFlid.jpg


tn_input.jpg


tn_gauge.jpg


tn_inputlid.jpg


tn_gaugelid.jpg


tn_potdone.jpg


I had one small leak that was found with soapy water. The pot has been hold steady at 40psi for the last 2 hours. I think I'll be ready to cast with this pot tomorrow.
 
Back
Top Bottom