where to buy large diameter gold tubing?

Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Chris; Unless you are thinking of making a very expensive pen, I would use brass instead of gold. I would also look at rummage sales for gold earrings or buy gold earrings and use them. Jim S
 
I'm looking to do a small run of pens and it'd be easiest for me to find a tube that had the proper dimensions, but all the jewelry suppliers don't seem to carry gold tubing in anything bigger than 1/4".
 
Most of the large tubing went to special order because the cost killed the demand. You can get it made but the minumum would be staggering. Most Jewelers would buy a strip of sheet and form it or cast it to size themselves. Do you have a specific set of dimensions you need and what karat? You may have better luck having it cast for you.
 
A good solution would be to turn them out of Hard wax, Like File-A- Wax or Matt Wax. Then send them to a casting house to be cast in the karat you want. A casting service will already have the gold casting grain on hand and you wont have to invest in extra material that is needed for the sprue and button. You will only pay for the weight of gold you use.
 
I am currently making 1mm and 2mm wide brass decorative rings in nickel plate and 24kt gold plate in varying diameters, .5" is one of the diameters. They are not yet available.
 
Chris; Why don't you contact BradG, he does gold plateing. Tell him what you need size wize , and he can tell you if it can be done. Jim S
 
You must log in or register to reply here.
Back
Top Bottom