Brentda1
Member
Quick question from a semi-newbie. I have been turning for about 3 years and doing pens for about 2 years....just simple slimlines. This past weekend stepped up to doing some Wall Street II from Woodcraft. Have drilled the blanks with the recommended bit (27/64) but the fit of the tube in the blanks seems a little sloppy. I drilled a piece of 2x4 taking care to make sure the piece was stable. It is still sloppy. Did I get a bad bit or is the nature of the beast with these kits.
I turned one pen after putting the tube in the blank with epoxy and it seemed to do well.
Thanks for the comments.
Brent
I turned one pen after putting the tube in the blank with epoxy and it seemed to do well.
Thanks for the comments.
Brent