Vicmarc Cole Chuck HELP!

[More4dan]

I have a Rikon 70-220 VSR with a 12 1/2" swing. I'm looking for Cole jaws for my Vicmarc chuck and was wondering if the 10" version will work with my lathe.

Also, CSUSA has them listed as 10" and Woodworkers Emporium has them listed as 285mm (11 1/4"). Are theses the same ones?

Any help would be most appreciated.

Thanks,

Danny




Sent from my iPad using Penturners.org mobile app

 

[Curly]

If you PM me I can give you the Canadian distributor for Vicmarc lathes and chucks in Calgary. He will know which is which.

 

[Wildman]

Not sure which Vicmarc chuck you have just assume VM100 but looks like their 10" bowl/cole jaws fit all three size chucks. So think they should work with your chuck & lathe.

Packard Woodworks: The Woodturner's Source: Vicmarc VM100 Jaws

Packard Woodworks: The Woodturner's Source: Vicmarc VM120/150 Jaws

 

[More4dan]

Not sure which Vicmarc chuck you have just assume VM100 but looks like their 10" bowl/cole jaws fit all three size chucks. So think they should work with your chuck & lathe.

Packard Woodworks: The Woodturner's Source: Vicmarc VM100 Jaws

Packard Woodworks: The Woodturner's Source: Vicmarc VM120/150 Jaws

Thanks, I was wondering what the expanded OD of the Cole Jaws are to see if it would work on my lathe.

Danny


Sent from my iPad using Penturners.org mobile app