Umatilla, Florida says hello

Signed-In Members Don't See This Ad
Garry Hirsch

Garry Hirsch

Member
Joined
Jan 19, 2011
Messages
19
Location
Umatilla, Florida
Hi to all,

I am interested in turning but have not yet purchased a lathe, although I'm leaning towards the Delta 46-460. I'm somewhat confused by the terminology so I'm doing a lot of research on the internet regarding pen turning primarily. Is there a beginner pen turning forum or internet location to help green novices like me? Thanks for all of your help in advance,
Garry
 
Signed-In Members Don't See This Ad
Welcome to the forum from Michigan. This forum is the best, from beginner to advanced, you can find what you need here.
 
Hi CaptG,

You certainly reached the right place, my friend...!

Welcome to the group, and good luck with your search.

Remember, don't be shy in asking questions, we all went trough the same...!

Cheers
George
 
Welcome Garry. If there is a Woodcraft store near you they have penturning classes that will get you started. At least the ones around the Cincinnati do.
 
Welcome. You can't go wrong with that Delta lathe. It is my second lathe. I also have a Nova 1624-44 that I have had several years. I haven't touched the Nova since I bought the Delta. I'm thinking about selling the Nova.

By the way I live just about 30 miles from Umatilla but it is in Oregon.
 
Welcome aboard from Wichita Falls, TX, here is where I throw a wrench in the suggestions, I say go for a Jet 1220VS lathe, Amazon.com sells them for a great price under what you would pay in the stores and there is usually free shipping! and no tax, or at least none for me.
 
Greetings, Garry, and Welcome to the Forum.

One good piece of advice would be for you to leasrn the use of the 'Search' function here, and to check out all the 'stuff' in the Forum's Library.

Ask questions if you don't find or understand what you do find there.
 
Hello Garry, I am located in Apopka. I have a daughter and her family in Umatilla. I have been turning for 4 years and enjoy it very much. I have been retired for 5 years. If I can be of any help , let me know.
 
John it was your review that has me leaning toward the delta.
Hi Gerry and welcome to IAP. Lots of good info hear about pen turning, bowls, etc. I have the Delta lathe you are considering and like it a lot. In fact, did a product review, you can find it here ..http://www.penturners.org/forum/showthread.php?t=58041
Click to expand...
I found it at Tool King.com for 579.66 with free shipping. Any body know Tool King good or bad ??
 
You must log in or register to reply here.
Back
Top Bottom