Nolan
Member
Could I get your guys and gals opinions on the best all around chuck for turning bowls and other stuff of the like. Thanks
Nolan
Nolan
Hey Kevin I am pretty sure you alread know but just in case alot of chucks have a safety pin that will effect how far it will open and close on one of the jaws. You may want to double check that you have the jaw with the safety pin set in the position that has the longer slot.Originally posted by dubdrvrkev
<br /> One thing I noticed is that between the two there is a small difference on how far they will close. I had turned some blanks down in one chuck so the tennon was just big enough to fit and in the other chuck it was a little small to get a good grip.
Originally posted by Ron Mc
<br />I see a lot of comments in regards to teeth and holding power. Could I get someone to take a picture of a piece of wood that is mounted and ready to turn? I too would like to make some bowels and have plenty of wood waiting until I figure out how to do it.[)]
Originally posted by Ron Mc
<br />I see a lot of comments in regards to teeth and holding power. Could I get someone to take a picture of a piece of wood that is mounted and ready to turn? I too would like to make some bowels and have plenty of wood waiting until I figure out how to do it.[)]
Originally posted by Rudy Vey
<br />Check this out: Craft Supplies has the SuperNova2 chuck on sale until Friday for $169.99 - and at the moment the shipping of over $100 is free!!
Originally posted by dubdrvrkev
<br />You can get a SN2 from www.woodchipshome.com for a very reasonable price. Tell him I sent ya[] Well that wont help out any but tell him anyway.