Matt8643
Member
I am turning a turquoise Tru Stone. It is already wet sanded and just needs to be polished, however, there are a few pits in the black matrix that runs through it. This is the second time this has happened to me. I turned a Jasper Tru stone that had a few pits in the black portions also. After wet sanding, the pits were white due to slurry that filled them. I was able to get the slurry out with a small paint brush and acetone. So all i need to do is fill the pits. I dont know whether to give it a CA finish and see if the holes fill in or to fill the holes with drops of medium CA. I just worry about the filled pits turning white or cloudy during wet sanding if I choose the latter. Any advice?
Attachments
Last edited: