Threaded brass coupler on 30 Cal nib

[jcm71]

A new first for me in how to screw up a pen on assembly. When pressing in the finial of a just completed 30 cal pen, I crimped the threads on the coupler that the nib screws on to. Nib section was pressed in first. Can that be punched out and a new thread assembly installed? If so, does anyone know where I can get a replacement? Many thanks. By the way, I was able to thread the nib onto the remaining thread, but it is literally hanging on by the proverbial one.

 

[Silverado]

Get a good grip on copper nib and just twist to tighten. It will pull the threading out to wear it should be. I have had that happen to me before also. Always press with copper nib in place.

Hope this helps.

Tim

 

[magpens]

PSI would probably sell you one if you phone them at the number on the home page of their website. . They don't often answer emails, I understand.