CREID
Member
I just turned a 3/8 tube for an Executive with an acrylic blank. I turned it round with a round carbide, and then, (I think this where the pause goes), I switched to the "Dreaded Skew". It started out fine, then about half way through I started getting a little chatter. I adjusted the angle and remembered to go downhill. I finally finished the barrel, with the "Dreaded SKEW". There was a little sanding needed but I did finish with the "Dreaded SKEW". You know, with a couple more wins like that, I might actually believe the tide of this war with the "Dreaded SKEW" can turn. I know it's just one battle, but it was a big one! I may need a few days rest, it was a tough battle after all. But I will be back in the trenches soon as I have 3 more of those Exec's to do and then affix a decal and finish.:beat-up: