table saw hold down ?

[old folks]

I have a Delta T 2 fence on my new table saw and I would like to get a hold down that does not require drilling into the fence for instiluation.
Thank yo

 

[VisExp]

I have a pair of these and find them useful for stop blocks, sacrificial fences etc.

http://www.rockler.com/product.cfm?Offerings_ID=17821

 

[randyrls]

I have a pair of these and find them useful for stop blocks, sacrificial fences etc.

http://www.rockler.com/product.cfm?Offerings_ID=17821

To join the thread; I have a "tall fence" that attaches to the fence on the saw. About 4" from the table surface route or dado a 3/4" slot about 3/8" deep. It will fit a standard feather board. I make these out of MDF (shelving). Easy to make and disposable Instant Hold down!

I have a fence that is extruded aluminum with slots and channels milled into the top and front.