So this summer Doug (Alankulwicki7) came to Faith for a little visit. While he was here we talked about bowl turning. I showed Doug a bowl I had turned and he looked it over. He asked me how I was sanding them. (That bad huh?:redface I told him I was hand sanding. He said I should look into power sanding that I wouldn't regret it. So I took his advice, but me being me (I'm sure Wayne, Bob, and Doug won't be surprised by this) I made a set. I found a good write up here and followed it pretty closely. Here are my results.
While I was making these I decided to go ahead and make an adjustable jig for sharpening my bowl gouges. I had seen this on a youtube video and printed the plans and had them around the shop for quite a while.
Here is a link to the video and if you look in the description of the video you will find a link to the plans themselves.
And lastly I made a jig for sharpening my Olund tool. William (Triw51) made the tool for me.
While I was making these I decided to go ahead and make an adjustable jig for sharpening my bowl gouges. I had seen this on a youtube video and printed the plans and had them around the shop for quite a while.
Here is a link to the video and if you look in the description of the video you will find a link to the plans themselves.
And lastly I made a jig for sharpening my Olund tool. William (Triw51) made the tool for me.
Last edited: