Califo
Member
Hi everyone, I turned a few Sierras for Xmas gifts and one of them I may have reamed it in a way that the inner diameter of the tube is slightly large that doesn't have a good tight fit on the kit. Have any of you been able to fix this situation? I thought about placing a dab of thin CA around the edge of the inner tube and see if I could create a better fit but eventually it will wear out. Any other ideas?
Normally, I'd toss it and make another but on this case I finished it with a personalized decal and CA. I hate to redo it all over.
Thanks
Normally, I'd toss it and make another but on this case I finished it with a personalized decal and CA. I hate to redo it all over.
Thanks