mark james
IAP Collection, Curator
Robutacion and I could use some suggestions.
In this thread, George asked for assistance to get a VS Upgrade for his lathe: http://www.penturners.org/forum/f97/lathe-1624-44-head-upgrade-issues-146753/
So, is is now sitting in my basement looking very lonely.
I'll pull in some favors this week and get it checked out, then need to figure out shipping.
The packaged box is 45 lbs.
24" (long) x 13" (high) x 12" (Wide)
Value $600 US
I've done some preliminary estimates with DHL, Borderlinx, Fed Express, UPS, USPS.
It can be broken down into 2 boxes: Motor, and controller if need be.
Any suggestions on where I should look for options? Anyone have any experience with shipping to Australia would be greatly appreciated.
I thank you in advance.
In this thread, George asked for assistance to get a VS Upgrade for his lathe: http://www.penturners.org/forum/f97/lathe-1624-44-head-upgrade-issues-146753/
So, is is now sitting in my basement looking very lonely.
I'll pull in some favors this week and get it checked out, then need to figure out shipping.
The packaged box is 45 lbs.
24" (long) x 13" (high) x 12" (Wide)
Value $600 US
I've done some preliminary estimates with DHL, Borderlinx, Fed Express, UPS, USPS.
It can be broken down into 2 boxes: Motor, and controller if need be.
Any suggestions on where I should look for options? Anyone have any experience with shipping to Australia would be greatly appreciated.
I thank you in advance.