I'm gonna jump in here anyway. If you've seen my previous post with questions about applying a CA finish, you'll have seen that I started with a cheap Amazon CA pack of thin, medium and thick CA and accelerator spray. It was probably old stock, on top of sitting for almost a year before I used it; common consensus is that it had started setting up, causing issues with application, particularly major rippling with the medium stuff. I got a lot if good recommendations of alternatives to try that are better suited to finishing over adhesion, the most popular of which being GluBoost Fill N Finish.
Long story short, I recently received my GluBoost order and have already used it on a few pens, and I'm just blown away. Having only done two pens previously with the cheap stuff, I'm very inexperienced with CA finishes, so I was expecting a bit of a learning curve with GluBoost. But between the great info I got here and in countless videos, I had a really good idea of what to do (and what NOT to do), and I was able to hit the ground running. From the very first pen I finished with it, I had immediate success. The stuff is just amazing.
I should make it clear that I'm retired and basically a cheapskate, usually looking for the most budget-friendly options when given a choice. That's the way I went with my first attempt at using CA. As someone pointed out in another thread, it is very much worth the added cost of a better finishing product like GluBoost. They were absolutely correct.
To answer your last question, from what I have seen it is highly recommended to NOT use an alternative accelerator with GluBoost, as it will likely cloud up, where GluDry will not. So I wouldn't chance it.