Segmented oval Le Roi with G-10 infills

Signed-In Members Don't See This Ad

Dieseldoc

Member
Joined
Oct 28, 2017
Messages
1,511
Location
Livermore, Ca 94550
Have been working with the G-10 infill and finding way to cut blanks without chewing up band saw blades as G-10 is epoxy fiberglass real hard stuff.
Found that I could use a carbide or Diamond hole saw and use the Gabe Castro jig to make this pen. Blank was just a scrap chuck of white Oak with Walnut being the end caps.

Note the photos have a orange tint, caused from all the smoke from our fires in the state. Photo's were take out side using natural light.
 

Attachments

  • IMG_3311.jpg
    IMG_3311.jpg
    717.1 KB · Views: 295
  • IMG_3312.jpg
    IMG_3312.jpg
    681.5 KB · Views: 284
  • IMG_3313.jpg
    IMG_3313.jpg
    699.8 KB · Views: 256
  • IMG_3314.jpg
    IMG_3314.jpg
    694.7 KB · Views: 256
Signed-In Members Don't See This Ad
Top Bottom